IllustrationGMC PAPER WORK ADMITS A DESIGN DEFECT, LOOKING FOR OTHER POWER TRANSMISSION FAILURES. *AK
1997 Chevrolet Camaro
Owner reports · Recalls · Investigations
Similar to other model years
Owner complaints for the 1997 Chevrolet Camaro do not stand out strongly from the model-year median of 32.
About this comparison →How this year compares
Owner complaints by model year
Compare all Camaro years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
All reported categories
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 12 of 69 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Engine And Engine Cooling. Review the 13 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Air Bags. Review the 8 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Service Brakes, Hydraulic. Review the 8 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
12 crash reports3 fire reports9 injury reports
Power Train complaints
7 reportsDRIVESHAFT FAILED IMMEDIATELY AFTER PURCHASE, POSSIBLY RELATED TO THE INSTALLATION OF UNBALANCED DRIVESHAFT. *YH
VEHICLE HAS EXTREME VIBRATION WHILE DRIVING AT 60 MPH DUE TO DRIVESHAFT WEARING OUT. *AK
1997 CAMARO-THE REAR WHEEL AXLE SPINDLE BROKE CAUSING THE REAR WHEEL TO BREAK OFF WHILE TRAVELING AT 45MPH. VEHICLE CAUSED DRIVER TO LOOSE CONTROL HIT HEAD ON IN A DITCH EMBANKMENT, THEN ROLLING OVER AND SLIDING ABOUT 15 FT. THUS CAUSING WHIPLASH TO THE DRIVER AND COMPLETE TOTAL OF VEHICLE
DEALER HAS BEEN JERKING ME AROUND. REPLACED THE INTAKE MANIFOLD GASKET ONCE. YEAR WENT BY, GOT ANOTHER OIL LEAK AND THE WATER PUMP WENT UP. TOOK TO THE DEALERSHIP, THEY REPLACED WATER PUMP, BUT DIDN'T FILL THE COOLANT BACK UP. THEY ALLEGED TO HAVE FIXED THE INTAKE MANIFOLD GASKET AGAIN. STILL GETTING AN OIL LEAK. CHECKED T…
Read full complaint
DEALER HAS BEEN JERKING ME AROUND. REPLACED THE INTAKE MANIFOLD GASKET ONCE. YEAR WENT BY, GOT ANOTHER OIL LEAK AND THE WATER PUMP WENT UP. TOOK TO THE DEALERSHIP, THEY REPLACED WATER PUMP, BUT DIDN'T FILL THE COOLANT BACK UP. THEY ALLEGED TO HAVE FIXED THE INTAKE MANIFOLD GASKET AGAIN. STILL GETTING AN OIL LEAK. CHECKED THE PROBLEM MYSLEF AND FOUND OIL COMING FROM PINION SEAL. DEALERSHIP SAID THAT IT WASN'T LEAKING WHEN I JUST HAD THE WATER PUMP FIXED. THEY CHARGED ME TO REPLACE THE PINION SEAL, EVEN AFTER TALKING TO THE SERVICE MANAGER, CHEVROLET AND GMPP, THE EXTENDED WARRENTY PROVIDER. AFTER THE SEAL WAS REPLACED I NOTICE A HUM AT 35MPH+. DEALER SAYS IT'S NORMAL, EVEN THOUGH I'VE NEVER HAD IT BEFORE. I CHECKED THE FLUID LEVEL IN THE REAR, AND IT WAS A QUART LOW ON OIL. NOONE SEEMS TO WANT TO DO ANYTHING TO HELP ME. *AK
I WAS DRIVING IN A SMOOTH HIGHWAY W/ NO BUMPS OR DEBRIS ON THE ROAD WHEN THE INCCIDENT HAPPENED.
OWNER COMPLAINING OF DRIVE SHAFT VIBRATIONS.
Official recalls
196V219000 · Seat Belts:front:retractor
Nov 4, 1996
THESE VEHICLES WERE MANUFACTURED WITH SEAT BELT RETRACTORS OUT OF DESIGN POSITION WHICH CAN CAUSE THE RETRACTOR TO LOCK-UP ON SLOPES LESS SEVERE THAN THE FMVSS REQUIREMENT. THIS DOES NOT COMPLY WITH FMVSS NO. 209, "SEAT BELT ASSEMBLIES."
Consequence & remedy
Consequence: IN THE EVENT OF A VEHICLE COLLISION, UNBELTED OCCUPANTS ARE MORE AT RISK OF INJURY THAN THOSE USING SEAT BELTS.
Remedy: DEALERS WILL INSPECT THE SEAT BELTS FOR PROPER FRONT SEAT BELT RETRACTOR POSITION. RETRACTORS FOUND TO BE IMPROPERLY POSITIONED WILL BE REINSTALLED CORRECTLY.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
2EA97024 · Fuel Tube Retaining Clip Failure
Opened Nov 13, 1997 · Closed Sep 29, 1998
Status: closed (inferred from source dates) · Vehicle Speed Control:linkages
MOST OF THE REPORTS REVIEWED IN THIS INVESTIGATION ARE FIRE INCIDENTS IN WHICH FUEL LEAKAGE HAS BEEN ALLEGED AS THE CAUSE OR THE AREA OF ORIGIN IS CONSISTENT WITH THE ALLEGED DEFECT.THERE IS NO EVIDENCE THAT THE SUBJECT CLIP WAS A FACTOR IN ANY OF THESE FIRE INCIDENTS AND NHTSA TESTING INDICATES THATBROKEN OR DISLODGED RETENTION CLIP DOES NOT RESULT IN SIGNIFICANT MOVEMENT OF THE FUEL LINE BUNDLE TOWARD THE LEFT SECONDARY AIR INJECTION CHECK VALVE.FAILURE OF THE CLIP PLACES THE FUEL LINE BUNDLE ASSEMBLY IN THE SAME CONFIGURATION AS THE 1993 MODEL YEAR LTI VEHICLES.A SAFETY-RELATED DEFECT TREND HAS NOT BEEN IDENTIFIED AT THIS TIME AND FURTHER USE OF AGENCY RESOURCES DOES NOT APPEAR TO BE WARRANTED.THE CLOSING OF THIS INVESTIGATION DOES NOT CONSTITUTE A FINDING BY NHTSA THAT NO SAFETY-RELATED DEFECT EXISTS.THE AGENCY RESERVES THE RIGHT TO TAKE FURTHER ACTION IF WARRANTED BY THE CIRCUMSTANCES.
PE97036 · Fuel Tub Retaining Clip Failure
Opened Jul 24, 1997 · Closed Nov 13, 1997
Status: closed (inferred from source dates) · Vehicle Speed Control:linkages
OWNERS HAVE REPORTED FAILURES OF THE FUEL TUBE RETENTION CLIP THAT ATTACHES TO THE PLASTIC THROTTLE LINKAGE COVER.ACCORDING TO GM, THE SUBJECT RETENTION CLIP (P/N 12048089) WAS IMPLEMENTED IN PRODUCTION ON OCTOBER 12, 1993, TO ADDRESS A CONCERN WITH INCORRECT ASSEMBLY PLANT FUEL LINE ROUTING.MIS-ROUTED FUEL TUBES MAY FAIL FROM CONTACT WITH A HOT AIR CHECK VALVE, CREATING A FIRE HAZARD IN THE ENGINE COMPARTMENT.GM MAINTAINS THAT NO PROBLEMS SHOULD OCCUR IF THE CLIP IS PROPERLY INSTALLED AND ISN'T MISHANDLED DURING SUBSEQUENT SERVICE OPERATIONS.SOME OWNERS HAVE ALLEGED TO ODI THAT THE SUBJECT CLIP BECOMES BRITTLE OVER TIME AND MAY ALSO PULL FREE OF THE THROTTLE LINKAGE COVER ATTACHMENT HOLE.