Electrical SystemEngine And Engine CoolingSteering
THE VSS FAULT LIGHT CAME ON AND THE ENGINE BEGAN RUNNING ROUGH AS IF IT WAS NOT HITTING ON ALL SPARK PLUGS WHEN I WENT INTO A TURN. I PULLED OVER AND SHUT OFF THE ENGINE, WAITED A FEW MINUTES, AND RESTARTED THE VEHICLE. THIS ALLOWED THE COMPUTER TO REBOOT. THIS HAS OCCURRED THREE TIMES SINCE. LATER, MY FRONT TRUNK RELEASE BU…
Read full complaint
THE VSS FAULT LIGHT CAME ON AND THE ENGINE BEGAN RUNNING ROUGH AS IF IT WAS NOT HITTING ON ALL SPARK PLUGS WHEN I WENT INTO A TURN. I PULLED OVER AND SHUT OFF THE ENGINE, WAITED A FEW MINUTES, AND RESTARTED THE VEHICLE. THIS ALLOWED THE COMPUTER TO REBOOT. THIS HAS OCCURRED THREE TIMES SINCE. LATER, MY FRONT TRUNK RELEASE BUTTON QUIT WORKING AND THE RIGHT FOG LIGHT QUIT WORKING (BULB IS FUNCTIONAL) AND MY GAS MILEAGE HAS GONE DOWN. I HAD NONE OF THESE PROBLEMS UNTIL THE DYNAMIC POWER STEERING UNIT WAS REPLACED DURING A RECALL. *TR
Bombardier Recreational Products Inc. (BRP) is recalling certain model year 2008-2009 Can-Am Spyder GS and model year 2010 Can-AM Spyder RS vehicles. Fuel vapors may exit the fuel vapor canister vent hose in the enclosed engine compartment.
Consequence & remedy
Consequence: Fuel vapors in the presence of an ignition source could result in a fire and personal injury.
Remedy: BRP will notify owners, and dealers will inspect the fuel vapor canister vent hose and replace and re-route it, as necessary, free of charge. The safety recall began on December 26, 2012. Owners may contact BRP AT 1-888-638-5397.
Bombardier Recreational Products Inc. (BRP) is recalling certain model year 2008-2012 Can-Am Spyder GS, RS, and RT series vehicles. The fuel cap may not fit onto the fuel tank filler neck, preventing it from sealing properly.
Consequence & remedy
Consequence: If the fuel cap does not seal properly, it may leak fuel vapors. Fuel vapors in the presence of an ignition source could result in a fire and personal injury.
Remedy: BRP will notify owners and send them a replacement fuel cap, free of charge. The safety recall is expected to begin in mid-January 2013. Owners may contact BRP AT 1-888-638-5397.
BRP IS RECALLING CERTAIN MODEL YEAR 2010 SPYDER RS SE5 2ND SERIES AND RT SE5 ROADSTERS. WHEN BRINGING A VEHICLE EQUIPPED WITH THE SE5 SEMI-AUTOMATIC TRANSMISSION TO A FULL STOP, THE CLUTCH MAY REMAIN ENGAGED STALLING THE ENGINE. ONCE THE ENGINE IS STALLED, IT COULD BE IMPOSSIBLE TO RE-START AND THE REAR WHEEL COULD BE BLOCKED.
Consequence & remedy
Consequence: IF THIS HAPPENS, THE VEHICLE MAY NOT BE ABLE TO BE PUSHED OFF THE ROADWAY INCREASING THE RISK OF A CRASH.
Remedy: BRP WILL NOTIFY OWNERS AND DEALERS WILL REPAIR THE VEHICLES FREE OF CHARGE. THE SAFETY RECALL BEGAN ON JUNE 7, 2010. OWNERS MAY CONTACT BRP AT 1-888-638-5397.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0
No exact-year investigations in this snapshot.
2010 CAN-AM Spyder Rs Problems, Complaints & Recalls | Skip That Year
Illustration