IllustrationCLUTCH FAILED CAUSING MOTORCYCLE TO STALL IN GEAR. BACK WHEEL LOCKED UP AND BIKE COULD NOT BE PUSHED OUT OF THE ROAD. WHEN THE CLUTCH FAILED IT RUINED THE MOTOR AND TRANSMISSION BEYOND REPAIR. *TR
2008 CAN-AM Spyder Rs
Owner reports · Recalls · Investigations
Limited comparison data
There is not enough comparable history to draw a useful model-year comparison.
About this comparison →How this year compares
Owner complaints by model year
Compare all Spyder Rs years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
All reported categories
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
320–25K
325–50K
050–75K
075–100K
0100–150K
0150K+
35 reports with mileage · 2 unknown
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Steering. Review the 22 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Fuel System, Gasoline. Review the 6 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Engine. Review the 4 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
1 crash reports8 fire reports1 injury reports
Power Train complaints
3 reportsBRP ISSUED SERVICE BULLETINS SB-2009-01 IDENTIFYING FAILURE OF THE GEAR POSITION SENSORS ON SOME OF THEIR CAN AM SPYDER ROADSTERS. SYMPTOMS OF FAILURE INCLUDE "E" OR INCORRECT GEAR NUMBER INDICATED IN CLUSTER INDICATOR; INTERMITTENT POWER STEERING OPERATION; DIFFICULTY SHIFTING; "CHECK ENGINE" WARNING SCROLL IN CLUSTER INDICATOR…
Read full complaint
BRP ISSUED SERVICE BULLETINS SB-2009-01 IDENTIFYING FAILURE OF THE GEAR POSITION SENSORS ON SOME OF THEIR CAN AM SPYDER ROADSTERS. SYMPTOMS OF FAILURE INCLUDE "E" OR INCORRECT GEAR NUMBER INDICATED IN CLUSTER INDICATOR; INTERMITTENT POWER STEERING OPERATION; DIFFICULTY SHIFTING; "CHECK ENGINE" WARNING SCROLL IN CLUSTER INDICATOR. PRESENTED TO AUTHORIZED DEALER FOR SERVICE 3 TIMES WHILE UNDER WARRANTY, UNSUCCESSFUL REMEDY WAS RESET OF GEAR POSITION SENSOR. PRESENTED TO SAME DEALER AFTER EXPIRATION OF WARRANTY, REMEDY WAS REPLACEMENT AT CUSTOMER EXPENSE IN EXCESS OF $200. BRP FACTORY TECH AT BRP EVENT INDICATED THAT REPLACEMENT WAS PROPER REMEDY. FAULTY ORIGINAL MANUFACTURER INSTALLED GEAR POSITION SENSORS ARE REPLACED WITH NEW DESIGNED PART FROM BRP ONLY AT OWNERS EXPENSE. *TR
BRP, DESPITE ISSUING SERVICE BULLETINS ABOUT HIGH DRIVE BELT TENSION, WILL NOT REPAIR DAMAGE CAUSED BY THE HIGH TENSION SPECIFIED IN MANUFACTURE AND SERVICE FOR THEIR CAN AM SPYDER ROADSTER. TSB 2010-06 ADVISES REDUCED TENSION FROM 1400 NEWTONS TO 450 NEWTONS TO PROTECT AGAINST DAMAGE TO FRONT OUTPUT SHAFT AND REAR BEARING FAILU…
Read full complaint
BRP, DESPITE ISSUING SERVICE BULLETINS ABOUT HIGH DRIVE BELT TENSION, WILL NOT REPAIR DAMAGE CAUSED BY THE HIGH TENSION SPECIFIED IN MANUFACTURE AND SERVICE FOR THEIR CAN AM SPYDER ROADSTER. TSB 2010-06 ADVISES REDUCED TENSION FROM 1400 NEWTONS TO 450 NEWTONS TO PROTECT AGAINST DAMAGE TO FRONT OUTPUT SHAFT AND REAR BEARING FAILURES. CONSEQUENTLY, COSTS TO REPAIR DAMAGE RESULTING FROM THEIR ORIGINAL TENSION SPECIFICATION ARE ASSESSED TO THE OWNER. REPAIR COSTS ARE IN EXCESS OF $2,000. *TR
Official recalls
0No recalls in this snapshot.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0No exact-year investigations in this snapshot.