2019 BMW X3

UNKNOWN cause. while driving approximately 45–55 mph, the vehicle experienced a sudden and unexpected braking event and engine shut down. •The vehicle automatically came to an abrupt, complete stop. •The engine shut off and then immediately restarted automatically. •A “Service Rear Pads” warning appeared after the vehicle auto-restarted. The vehicle did not gradually slow down; it suddenly and forcefully braked to a complete stop and shut down completely. This was a serious and potentially dangerous safety event as an unexpected stop/shut down event at 45–55 mph could have created a significant risk of collision. We contacted the BMW service center and scheduled a diagnostic appointment for June 22. During the June service visit, the dealership performed: diagnostics, rear brakes and rotors replacement, A/C recharge, tire rotation and balance, and oil change/service. Following the June service, we began experiencing new and intermittent symptoms that had not been present before, including: Ticking, metal clanking, new road/tire noise, Changes in vehicle dynamics and overall driving feel, other intermittent noises. On July 21, we contacted BMW to report the new intermittent noises and changes following the June service and requested an appointment to have these concerns evaluated. An appointment was scheduled for July 24. The July MPI identified several concerns that differed substantially from the June MPI, including: Rear differential leak, worn motor mounts, low battery concerns, & uneven tire wear and cracking. We also observed a permanent brake-pad imprint on a new rotor. These discrepancies raised additional questions and we were told by the SM that the technician had “missed” them in June, even though he documented as good. We refused to accept the X3 back for now d/t safety concerns, and we notified BMW of North America for investigation. The cause for the critical shut down event remains unknown. How can Flow BMW assure it's safe to drive?

hello I am formally reporting: Safety‑Critical Failures and Applicable Federal Requirements the attached 2019 BMW X3 – VIN [XXX] 1. Rearview Camera Failure Federal Requirement: FMVSS 111 – Rear Visibility Relevant Obligations: - Rearview image must activate automatically when shifting into reverse. - System must provide a minimum field of view. - System must function reliably under normal operating conditions. Failure: The rearview camera failed completely, resulting in loss of federally required rear visibility. 2. Emergency Call (eCall) System Malfunction Federal Requirement: 49 CFR § 573 – Defect and Noncompliance Responsibility (NHTSA considers eCall part of the post‑crash safety architecture.) Relevant Obligations: - Manufacturers must investigate safety‑related failures. - Manufacturers must determine defect scope and affected population. Failure: The vehicle displays “Emergency Call System Malfunction” warnings, indicating loss of automatic crash notification capability. 3. Forward Collision Warning / Pedestrian Warning Failure Federal Requirement: FMVSS 126 – Electronic Stability Control (ESC) - NHTSA ADAS Safety Guidance (Forward Collision Warning, Pedestrian Detection) Relevant Obligations: - ADAS systems supporting collision avoidance must function reliably. - Failures must be investigated for potential safety defects. - Manufacturers must document defect determination and scope. Failure: The vehicle displays warnings indicating failure of forward collision warning and pedestrian detection systems, impairing collision‑avoidance capability. 4. Telematics Control Unit (TCU) Failure Federal Requirement: 49 CFR § 573 – Defect Reporting - NHTSA Safety Recall Rules (TCU failures affecting safety systems) Relevant Obligations: - TCU failures affecting safety‑critical subsystems must be investigated. - Manufacturers must determine whether the failure constitutes a defect. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Beginning in July–August 2025, my 2019 BMW X3 (VIN [XXX] ) began experiencing multiple safety‑critical system failures affecting federally regulated components. The rearview camera intermittently failed to activate and later stopped functioning entirely, resulting in loss of rear visibility required under FMVSS 111. The Emergency Call (eCall) system displayed repeated malfunction warnings, indicating loss of automatic crash notification capability. The vehicle also displayed “Driver Assistance Restricted,” “Collision Warning Malfunction,” and pedestrian detection failure messages, showing that forward collision warning and related ADAS functions were not operating properly. During the same period, the telematics control unit (TCU) lost functionality. This caused loss of ConnectedDrive services, backend communication, remote diagnostics, remote status reporting, and safety‑related over‑the‑air updates. These failures match known BMW defect patterns involving water intrusion into the antenna/telematics module and backend provisioning issues. I submitted a detailed written escalation to BMW of North America. BMW issued two brief responses on February 11–12, 2026 that did not address any of the safety issues, did not provide the engineering basis for excluding my VIN from the applicable recall, and redirected me to a dealer, which has no authority over recall determinations. BMW closed the case without providing any investigation results, defect determination, or technical explanation, contrary to obligations under 49 CFR § 573. These failures materially impair federally regulated safety functions, including rear visibility, collision avoidance, emergency crash notification, and telematics‑based safety communication. The pattern suggests a potential broader defect affecting additional vehicles. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Starting in July/August 2025, my 2019 BMW X3 (G01) suffered a total failure of multiple safety-critical systems, including the Emergency Call (eCall) system, the rearview camera, and frontal collision/pedestrian alert sensors. These failures were accompanied by a persistent "Emergency Call System Malfunction" warning on the dashboard. BMW Service Information Bulletin SIB 65 12 22 acknowledges a manufacturing defect where the roof-mounted antenna housing seal was "not optimal," leading to water ingress. This water ingress has damaged the Telematics Control Unit (TCB), which manages these safety features. I have contacted BMW North America and local dealerships; however, they have provided a written refusal to repair the damaged internal electronics because the vehicle is out of its original 4-year warranty. Safety Risk: This defect leaves the vehicle in a non-compliant safety state. In the event of a crash, the vehicle cannot automatically notify emergency services (eCall failure). Furthermore, the loss of the rearview camera and collision avoidance systems significantly increases the risk of a crash or injury. BMW is aware of the defect that causes these safety systems to fail but has not issued a safety recall to address the resulting hardware damage. This issue is currently the subject of the Craft v. BMW of North America class-action lawsuit.

At some point in June 2025, between approximately 11 a.m. and 2 p.m., I was driving southbound on the 110 Freeway in Los Angeles, just south of the 134 interchange, at approximately 45 mph. Traffic was light, with no vehicles in front of me and no vehicles attempting to merge into my lane. Without warning, a bright red alert appeared on the dashboard of my 2019 BMW x3 and the vehicle suddenly applied full braking. The position of my arms at that moment caused an injury to my right elbow, which has remained painful since the incident. In January 2026, under nearly identical circumstances, the emergency warning appeared again. This time, the brakes did not engage. In July, I contacted BMW Corporate and service center regarding these incidents. I found their response dismissive, stating that “sometimes that happens.” A service center later informed me that this is a known issue referred to as “phantom braking.” Having experienced this firsthand, I believe this represents a serious safety concern. In addition to my injury, I could easily have been rear-ended at freeway speed. Despite acknowledging the issue, BMW Corporate requested that I sign an indemnity waiver in exchange for covering only the inspection cost. This response feels inappropriate, as their initial focus appeared to be limiting liability rather than addressing a known safety defect. Given that this is reportedly a known issue, I believe an inquiry is warranted into how often this has occurred and whether others have been injured.

1- Passenger Restraint System Malfunction error codes- related to wiring or front passenger seat- long timeframe and expense to diagnose 2- Engine mounts broken Oct 2023 and again Aug 2025- known issue by BMW service- high repair cost & repeat failure 3- Front crash assist will brake for shadows caused by trees or adjacent trucks and has nearly caused accidents

The automatic emergency braking system randomly applied itself while I was driving 40mph down a highway where there was no obstacle/animal of any kind. My vehicle braked hard and quickly and a red car image appeared in the dash simultaneously. Thankfully there were no other vehicles around me at the time. Prior to today, my vehicle has had regular maintenance and has had no issues. I have not yet brought his forward to a dealership, service center, police, insurance, etc.

The contact owns a 2019 BMW X3. The contact stated that on several occasions while driving at various speeds, the blind side indicators did not detect passing vehicles. The contact also stated that the lane departure feature, which vibrates and corrects the wheel, no longer worked as intended. The contact stated that there was a system indicator light on the dashboard that turned orange. The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure. The failure mileage was approximately 35,000.

The contact owns a 2019 BMW X3. The contact stated that upon starting the vehicle, the message "Driving Assistance Reduced and Pedestrian Warning not Working" was displayed on the instrument panel. The contact stated that while driving 40 MPH in stop and go traffic, the Collision Warning feature failed to function as intended. The contact depressed the brake pedal to stop the vehicle. Additionally, the contact stated that the rearview camera was not working as intended. The vehicle was taken to the dealer, where it was diagnosed that the KAFAS (Camera Assisted Driver Assistance Program) system was heated and needed to be replaced. The vehicle was not repaired. The contact related the failure to NHTSA Campaign Number: 21V096000 (Back Over Prevention). The manufacturer was made aware of the failure and advised the contact to file a complaint with the NHTSA Hotline. The failure mileage was approximately 62,000.

When driving on citi street at 40MPH the vehicle randomly initiated the automatic emergency breaking system. The vehicle almost came to a complete stop in the middle of morning traffic. Almost had the vehicle behind me rear end me. The vehicle was taken to BMW dealer and a software update was performed. This is the second time that this has occurred. The vehicle will periodically still display collision warning light when nothing is even near the vehicle.