2019 BMW X3

UNKNOWN cause. while driving approximately 45–55 mph, the vehicle experienced a sudden and unexpected braking event and engine shut down. •The vehicle automatically came to an abrupt, complete stop. •The engine shut off and then immediately restarted automatically. •A “Service Rear Pads” warning appeared after the vehicle auto-restarted. The vehicle did not gradually slow down; it suddenly and forcefully braked to a complete stop and shut down completely. This was a serious and potentially dangerous safety event as an unexpected stop/shut down event at 45–55 mph could have created a significant risk of collision. We contacted the BMW service center and scheduled a diagnostic appointment for June 22. During the June service visit, the dealership performed: diagnostics, rear brakes and rotors replacement, A/C recharge, tire rotation and balance, and oil change/service. Following the June service, we began experiencing new and intermittent symptoms that had not been present before, including: Ticking, metal clanking, new road/tire noise, Changes in vehicle dynamics and overall driving feel, other intermittent noises. On July 21, we contacted BMW to report the new intermittent noises and changes following the June service and requested an appointment to have these concerns evaluated. An appointment was scheduled for July 24. The July MPI identified several concerns that differed substantially from the June MPI, including: Rear differential leak, worn motor mounts, low battery concerns, & uneven tire wear and cracking. We also observed a permanent brake-pad imprint on a new rotor. These discrepancies raised additional questions and we were told by the SM that the technician had “missed” them in June, even though he documented as good. We refused to accept the X3 back for now d/t safety concerns, and we notified BMW of North America for investigation. The cause for the critical shut down event remains unknown. How can Flow BMW assure it's safe to drive?

I bought my 2019 BMW X3 late 2025 before Christmas. The Carfax was fine and there were no open recalls on the vehicle. The vehicle had been serviced regularly at BMW facilities. Our family mechanic looked at the vehicle before I bought it and performed some basic diagnostics. The vehicle appeared fine. There were no error codes and all of the fluids were topped off. I don't know if the issues with the coolant were there before I purchased the vehicle or if they happened afterwards. There were no warning lights and everything looked good. This car is garage kept and is used a couple of times a week. I did my research on the internet and took my car in for an oil change at a highly-rated independent auto repair facility that specializes in European vehicles and are famous for providing dealership-level expertise, ASE-certified with factory trained technicians from Germany. On March 5th, 2026, when I went to pick up my car, they told me the bad news that is a well known manufacturer defect within the industry regarding these vehicles. They used plastic components in the engine compartment and in the cooling system, which makes the vehicles malfunction. From their report, with pictures, they state the following repairs need to be made, "During the vehicle inspection noticed active coolant leaks are present from multiple locations. The radiator plastic tank actively leaking coolant. The water pump change over valve leaking coolant. The turbocharger coolant line has a coolant crud build up . Oil filter housing and coolant flange on the cylinder block are discolored. For proper cooling system repair recommend complete update of the cooling system. Both balance shaft end caps leaking oil. Recommend replacement during cooling system update." They quoted me $8,914.86 for this repair. That's over HALF the value of the vehicle. They said the entire system needs to be replaced because ALL of the plastic parts in Florida's hot sun will fail. Sudden coolant failures in FL = DEATH.

I am submitting this complaint regarding a serious mechanical and safety issue involving my 2019 BMW X3. On or around January 21, 2024, while driving from my home, a warning signal suddenly appeared on my dashboard related to the vehicle’s cooling system/engine. Due to safety concerns, I pulled into a nearby Wawa parking lot, which was the safest available place to stop at the time. I turned the vehicle off and waited approximately 15 minutes before carefully driving the vehicle back home. After inspection and diagnosis, I was informed that the vehicle required extensive repairs, including an engine replacement and cooling system repairs. At the time the coolant warning appeared, the replacement engine reportedly had approximately 59 miles on it. I believe a sudden engine or cooling system malfunction while operating a vehicle presents a serious safety concern for drivers, passengers, and others on the roadway. In addition, I experienced issues involving the shark fin antenna on the vehicle, which I understand may be connected to broader complaints involving BMW vehicles. I am requesting that NHTSA review this matter to determine whether these issues may indicate a broader defect or safety-related concern affecting other consumers. I am willing to provide supporting documentation including repair invoices, dealership records, photographs, and any additional information requested. Thank you for your attention to this matter and for your commitment to vehicle safety.

My 2019 BMW X3 equipped with a B46 engine developed a significant coolant leak at approximately 80,000 miles. The vehicle displayed a low coolant warning, and coolant was visibly leaking underneath the vehicle. Around the same time, I began noticing excessive white exhaust/steam during cold starts and, for the first time since owning the vehicle, had to add engine oil between scheduled oil changes. The vehicle is currently undergoing inspection by an independent repair facility. Preliminary findings indicate concerns involving premature failure of critical plastic cooling system and/or oil filter housing components. Based on my research, these failures appear consistent with widespread complaints involving BMW B46/B48 engine cooling system and oil filter housing defects. I am concerned this defect could lead to sudden coolant loss, overheating, engine failure, or unsafe driving conditions. Prior to the coolant warning appearing, there were no significant alerts indicating a major or imminent cooling system failure. The apparent failure of critical plastic engine cooling components under normal driving conditions raises serious concerns regarding the durability and safety of these parts. I have photographs documenting the coolant leak, as well as detailed notes and diagnostic information from the repair facility, available upon request. The vehicle is available for inspection.

I'm reporting a safety issue with BMW vehicles equipped with the B58 engine, primarily 2019-2021 models. These vehicles have an oil pump with an internal plastic component that regulates oil pressure, and this part is fracturing in the field, causing sudden loss of oil pressure. The failure typically occurs during cold starts in low temperatures. When it fails, oil pressure becomes erratic or is lost entirely, often with little to no warning before engine damage or vehicle disablement. Warning signs, when present, include inability to measure oil level electronically, abnormal oil pressure, or sudden drive train malfunction warnings. These can rapidly progress to engine shutdown or severe damage from oil starvation. This creates a dangerous situation because the vehicle can become disabled without warning while driving or after startup. This is especially hazardous when cars become immobilized in traffic or during winter conditions when failures occur most frequently, leaving occupants exposed to freezing temperatures while awaiting assistance. Pump replacement requires extensive disassembly and commonly costs $6,000-$8,000, assuming no engine damage. A critical concern: owners cannot determine if their vehicle has the original plastic pump or the later metal revision. BMW's VIN-based parts lookup now shows updated components even when original plastic parts remain installed, and BMW has removed the original plastic part number from dealer networks entirely. Failures are reported across multiple production years, and the scope of affected vehicles remains unclear. Because this condition causes sudden vehicle disablement without adequate warning, especially in cold weather, I believe this warrants investigation as a potential safety-related defect.

I'm reporting a safety issue with BMW vehicles equipped with the B58TU engine, primarily 2019-2021 models. These vehicles have an oil pump with an internal plastic component that regulates oil pressure, and this part is fracturing in the field, causing sudden loss of oil pressure. The failure typically occurs during cold starts in low temperatures. When it fails, oil pressure becomes erratic or is lost entirely, often with little to no warning before engine damage or vehicle disablement. Warning signs, when present, include inability to measure oil level electronically, abnormal oil pressure, or sudden drivetrain malfunction warnings. These can rapidly progress to engine shutdown or severe damage from oil starvation. This creates a dangerous situation because the vehicle can become disabled without warning while driving or after startup. This is especially hazardous when cars become immobilized in traffic or during winter conditions when failures occur most frequently, leaving occupants exposed to freezing temperatures while awaiting assistance. Pump replacement requires extensive disassembly and commonly costs $6,000-$8,000, assuming no engine damage. A critical concern: owners cannot determine if their vehicle has the original plastic pump or the later metal revision. BMW's VIN-based parts lookup now shows updated components even when original plastic parts remain installed, and BMW has removed the original plastic part number from dealer networks entirely. Failures are reported across multiple production years, and the scope of affected vehicles remains unclear. Because this condition causes sudden vehicle disablement without adequate warning, especially in cold weather, I believe this warrants investigation as a potential safety-related defect.

Reporting a failure of the engine cooling system on my 2019 BMW X3 that developed over time despite repeated repair attempts and ultimately resulted in complete engine failure. Over the past year, the vehicle has experienced ongoing coolant loss and overheating warnings despite multiple coolant-related repairs. When the problem continued, I brought the vehicle to a BMW dealership, where the service department determined that the engine had suffered internal damage consistent with overheating and advised that a full engine replacement was required. These issues occurred during normal driving and created unsafe conditions, including the risk of sudden loss of power or breakdown in traffic. Based on my experience and the repeated nature of the failures despite proper maintenance, it appears that coolant and overheating issues may be persistent in this vehicle model rather than isolated to a single component, and I am concerned that other owners may be experiencing similar safety-related defects. A investigation into this is warranted.

I am reporting repeated coolant system failures and overheating on my 2019 BMW X3 . I have had 4 coolant-related repairs in under 3 years, including the coolant reservoir boiling after service. Most recently, the problem recurred despite prior repairs. This is a Certified Pre-Owned vehicle with warranty history, and I believe this is a systemic engine/cooling defect that poses a risk of engine failure or fire. Other owners may be affected. A recall or investigation is warranted.

While driving my BMW X3, the engine suddenly failed after the check-engine light came on, which followed several days of intermittent high-temperature warnings. Coolant levels had been consistently monitored, refilled, and topped up as needed, yet the temperature fluctuations persisted. Upon further inspection, the repair shop determined that coolant had been leaking internally into the engine due to a cooling system failure, causing overheating and warping of internal components. This created a serious safety hazard, as the vehicle began losing power while in motion, leaving me unable to safely accelerate or maintain speed in traffic and increasing the risk of a collision and a potential fire. This is a serious matter and BMW should assume responsibility for this. I bought the car assuming it was reliable but having to endure this cost out of pocket for an engineering failure is not okay.

Despite replacing the water pump, coolant expansion tank, hoses, and other related cooling system components, and fully refilling and bleeding the coolant, the issue persisted. Even after these repairs, the engine continued to overheat and show coolant level fluctuations, indicating an underlying problem likely pressure buildup or head gasket failure that was not resolved by replacing standard cooling parts. Dealership has identified further problems and seem like a costly repair that I won’t be able to do out of pocket. BMW needs to address this issue immediately, engine stuttering and loss of sudden power on the high way is not safe!