2016 BMW M235I

BMW 2 series cars from about 2015-2018 have faulty wiring and brake light assemblies. BMW has admitted this design flaw in the harness and light - they extended the warranty for one year. As you know, brake light failures represent a real risk. It is unreasonable for BMW to charge $900 per light to fix a safety issue caused by a design flaw that they have admitted. THE CONSUMER STATED THE PASSENGER TAIL LIGHT HAS FAILED, ALSO.

Rear brake light failure due to faulty wiring. Identical to the details located in this article (https://www.autoblog.com/2011/09/01/bmw-recalling-241-000-3-series-models-over-faulty-tail-lights/) for which the NHTSA had issued a recall for older BMW models in the past. This issue is common and wide-spread amongst bmw models produced between 2014 - mid 2016. After which BMW modified the wiring harness for the brake lights to fix the electrical shorting failures. This failure renders the entire housing inoperable - Brake light, turn signal and reverse lamp. Summary: OVER TIME, RESISTANCE IN THE ELECTRICAL CONTACTS MAY CAUSE ONE OR MORE REAR LAMP FUNCTIONS (TAIL LIGHT, BRAKE LIGHT, AND/OR TURN-SIGNAL), WITHIN THE VEHICLE'S BODY PANEL, TO STOP WORKING. Consequence: INTERMITTENT LIGHT OPERATION REDUCES THE ABILITY TO WARN OTHER MOTORISTS OF THE DRIVER'S INTENTIONS. THIS COULD CAUSE A VEHICLE CRASH WITHOUT WARNING. I have attached a BMW TSB (SI_B63_05_17) which outlines that BMW was aware of this issue as early as October 2017 but did not issue a voluntary recall for an issue that warranted a recall in the past. My brake light housing failed as a result of the faulty ground wire 8 months after the extended warranty on these parts lapsed resulting in an estimated $1140 in repairs for a critical safety component for which I cannot operate the vehicle safely without. The vehicle is currently with a BMW dealership for inspection and repair. Warning messages appeared after the component had completely failed while driving. Incident occurred in early August 2021.